Push Control Button, 12 mm thread and Round connector

The AUTOTERM Push Control is a compact and user-friendly device designed to control AUTOTERM heaters,
offering various operating modes and functions depending on the specific heater model.
The set includes a control module and a cable for connecting to the heater.

It features an IP67 protection rating and a stainless steel housing,
making it waterproof and durable even in the toughest weather conditions.

• 12 mm thread and round connector

62,77 €

In stock

, plus

Available immediately
Delivery time: 1 - 3 Workdays (PL - int. shipments may differ)

SKU: 77874
Category: Control elements

Description

Air Heating

Heating Modes for Air Heaters

POWER MODE:
Default heating mode for the Push Control button.

TEMPERATURE MODE (Works only with an external temperature sensor connected):
Designed to heat the space to the desired temperature;
The heating power decreases as the difference between the desired temperature and the room temperature decreases.
* The temperature mode for the Air 2D 12/24V and 4D 12/24V heaters in the 6355, 6350, 6260, and 6265 series features a new algorithm. In this mode, the heater operates normally, reducing power as it approaches the set temperature. However, if it exceeds the set temperature point, the heater will shut off and wait until the temperature drops 3 degrees below the set point before restarting.

Water Heating

Heating Modes for Air Heaters

POWER MODE:
Default heating mode for the Push Control button.

Temperature Sensor:

Individually calibrated digital sensor with a deviation of +/- 1.5 degrees.

Status Display:

MIN = Blue
LOW = Purple
MED = Green
HIGH = Yellow
MAX = Red
Blinking Red - Error code
Blinking Red/Blue - Shutdown

Compatibility with AUTOTERM Heaters

AUTOTERM Air Heaters:

AUTOTERM Air 2D
AUTOTERM Air 4D
AUTOTERM Air 8D
AUTOTERM Air 9D

AUTOTERM Liquid Heaters:

AUTOTERM Flow 5D / 5B
AUTOTERM Flow 14D

Button surface diameter: 25 mm
Thread diameter: 25 mm