Gas heating Propex HS2800 air heater 2.78 kW for a camper, 1.248,86 €

Heat output: 2.78 kW
Fuel: LPG
Fuel consumption: 10 hours/gallon (continuous operation)
Air throughput: 85 CFM
Voltage: 12 V
Power consumption: 1.9 amps
Dimensions: length 160.4 x width 80.3 x height 40.8 mm

Control

The HS2800 comes standard with an electronic semiconductor thermostat, which automatically turns the device on and off to maintain the desired temperature. When the room temperature drops below the selected level, the heat source automatically turns on and will operate until the cabin reaches the chosen temperature. The thermostat is an easy-to-install surface-mounted design and integrates with the new electronics mounted in the HS2800 heaters. Unlike some heaters, during ignition, the current draw is minimal, so the cyclical turning on and off of the heat source does not cause additional battery discharge.

Performance

Combustion air is drawn from outside and introduced into the combustion chamber after mixing with gas during three stages of air supply, it is automatically ignited and heats a large surface area of the heat exchanger. Heatsource units are completely sealed and exhaust all combustion products outside through a neat 22 mm internal diameter stainless steel flue pipe. To increase efficiency, the air in the cabin is normally recirculated instead of cold air from outside. HS series heaters are also very efficient in terms of electrical power consumption, high-quality motor and fan connection, and innovative current-reducing electronics, both of which have been upgraded in the latest versions, meaning that even the larger HS2800 draws less than 2 A and the smaller HS2800 1.4A under normal operating conditions.

Quiet Operation

Propex heaters provide quiet operation without compromising air throughput and heat output. There will always be air noise from the system that generates healthy airflow, however, through the use of high-quality balanced fans and smoothly enclosed ball bearing motors, noise is minimized. High voltage also does not affect noise, which is a common occurrence when charging batteries, solar panels, etc., connected permanently. Microprocessor electronics regulate motor voltage, ensuring that the fan speed does not change from 10 to 15 volts.

EN Technical Specifications

EN Technical Specifications