The Simple Control PU-5 control device, manufactured by Autoterm, has been designed to enable easy and intuitive control of the Autoterm/Planar Air parking heater.
The device includes a knob and two function buttons that allow you to control various functions of the parking heating.
If a temperature sensor is connected, the device automatically switches to temperature mode, which allows it to be maintained
optimal temperature in the vehicle.
In addition, the device also has a ventilation mode that allows air to circulate in the vehicle when it is not heated.
If errors occur, the user will be notified by a flashing code.
The device is adapted to be powered by 12V or 24V on-board power.
Thanks to a simple and intuitive user interface, controlling the parking heater becomes easy and pleasant.
"Power mode"
(If the external sensor is not connected)
- Designed for quickest possible heating of the space.
- The heater operates continuously at a set power.
** "Temperature mode"
(If the external sensor is connected)
- Designed to heat the space to the required temperature;
- Heat output decreases as the difference between the desired temperature and the temperature in the space decreases.
* The temperature mode for Air 2D 12/24V and 4D 12/24V heaters in the 6355, 6350, 6260, and 6265 series versions have a new algorithm. In this mode, the heater acts normally by lowering power when it gets near the set temperature. However, if it goes past the temperature setpoint, the heater will turn off and wait until the temperature drops by 3 degrees below temperature setpoint before starting again.
* "Ventilation mode"
- Designed for air circulation in the space.
** “Ventilation during heating”
(If the external sensor is connected)
- Designed to maintain the required temperature in the space.
- After the required temperature is reached, the space heating is stopped and space air circulation is performer.
- Controls the space temperature; if the temperature drops below the set point, the heater will start in Ventilation mode.
* Please note, that AUTOTERM air heaters with production date 16.11.2016 or older does not support Ventilation mode. You can check your air heaters AUTOTERM production date on the warranty card.
** Please note, that all AUTOTERM air heaters need external temperature sensor (assy. 62926), so that the "Power mode" and "Ventilation during heating” function would work.
